Smart Kit with Wi-Fi Siren, Various Sensors and Remote Control

Smart Kit with Wi-Fi Siren and Remote Control Sensor

433MHz Wireless Intelligent Security Kit:Intelligent security system designed for home, office or small commercial premises protection. The system combines the function of a gateway and siren in a single device and is fully controlled through the Tuya Smart / Smart Life application, providing real-time monitoring and notifications.

Secure System:Thanks to WiFi connectivity and 433MHz wireless communication with sensors, the system provides rapid response in case of alarm, high-volume sound signal, and automation options with other Tuya devices.

Battery:The internal battery allows operation even in the event of a power outage. Backup lithium battery 4.2V 300mAh. Full charging time is about 5 hours.

Installation:

1. Downloading and Registering the Application

1. Download the Smart Life or Tuya Smart app from Google Play or the App Store.
2. Open the app and register with email
3. Log in to the application after registration.

2. Connecting the Siren to WiFi Attention: The system only works with 2.4GHz WiFi

Method 1 – Default Mode

1. Open the app and press “+” to add devices.
2. Select All Devices → Alarm System
3. Make sure the siren light is flashing quickly.
4. Enter the WiFi password and confirm.
5. The device automatically connects to the network.

Method 2 AP Mode (Compatibility Mode)

1. Used if connection with the first method fails
2. In the application, select AP Mode
3. Turn the siren off and on.
4. Hold down the RESET button for 5 seconds.
5. The light will flash slowly.
6. Enter the WiFi password (2.4GHz)
7. Connect to the SmartLife-XXX network from your phone's WiFi
8. Return to the app to complete the connection Important WiFi notes
9. Does not support 5G networks
10. Keep the siren and phone close to the router.
11. If that fails, restart the router.

3. Adding Sensors and Remotes

Method 1 – Through the Application

1. Open the device in the app
2. Select Accessories → Detector / Remote → Add
3. Press OK.
4. Activate the sensor:
5. Door sensor: move the magnets more than 2 cm away
6. PIR sensor: turn on the sensor
7. The siren light flashes 3 times, the addition is successful.

Method 2 – Through Siren

1. Press the RESET button on the siren.
2. The light stays on.
3. Activate the sensor or remote control
4. The light flashes 3 times the device was added successfully
5. Repeat for other devices

4. Naming Accessories

1. You can change the name of each sensor in the app.
2. The name can be up to 24 characters long.
3. Helps identify the alarm zone

5. Siren Installation

1. Remove the holder by sliding it off.
2. Fix the holder to the wall with screws.
3. Place the mermaid's body on the stand.
4. Rotate until fully seated.

6. Installing the Door Sensor

1. The distance between the magnet and the sensor must be less than 10 mm.
2. When the door opens and the light turns on, the installation is correct.
3. If the light flashes during activation, the battery is weak and needs to be replaced.

7. Usage and Maintenance Tips

1. Test the system every 3 months
2. Check sensor batteries every month.
3. Do not place multiple PIR sensors in the same area.
4. Avoid installing the PIR sensor in front of windows or heat sources.